![]() ![]() Use 22 AWG or larger (depending on the load) for all other connections. Suggested wiring size is 18 AWG for earth ground and power (up to 500 feet of 18 AWG wire can be run for power, use larger wire for longer runs). To avoid damage to the unit from static discharges, connect the EARTH GROUND terminal to a good earth grounding point. TIMED ANTI-PASSBACK (LAST 3 VALID ENTRIES)įigure 1.SOLID STATE OUTPUTS ARE OPEN COLLECTOR (SWITCH-TO-COMMON).EACH ENTRY CODE CAN BE PROGRAMMED TO ACTIVATE EITHER OR BOTH RELAYS.Humidity: 5% to 95% non-condensing FEATURES SPECIFICATIONSĬase dimensions: 4.00" W x 5.50" H x 3.00" D The EEPROM memory retains all entry codes and programming, even without power. Power can be obtained from the access device or a separate power supply. ![]() The AK-11 is powered from a 12-24 Volt AC or DC source. Two solid state outputs, capable of switching 100 mA to common, are programmable to signal forced entry, door ajar, lockout, alarm circuit shunting, request-to-enter, and keypad active conditions. This output can be wired to shunt alarm contacts on the access door/gate to prevent triggering of an alarm when authorized access occurs. The ALARM SHUNT output activates when access is granted. The "anti-passback" feature prevents using the same code twice before the programmed time elapses. The REQUEST-TO-ENTER input can be wired to a pushbutton or fire access keyswitch to provide codeless entry for authorized personnel. If programmed for "inhibit", the input can be wired to a "service" switch or automatic timer that will disable the Relay #1 when required. If programmed for "door sense", a switch on the door detects forced entry or door ajar situations. The DOOR SENSE/INHIBIT input can be used two ways. An internal sounder beeps when each key is pressed. The keypad's courtesy light can be always off, always on or be programmed to illuminate from 1-4 minutes after any keypress (default 2 minutes). The right LED lights yellow when the keypad is in "lockout" condition (from too many incorrect code entries). The left LED lights red to indicate power, then turns green when access is granted. ![]() Two LED indicators show the status of the entry system. They can activate either, or both, of the relay outputs. Up to 480 entry codes, from 1 to 6 digits in length, can be programmed. The die-cast keys have bright, easy-to-read yellow graphics. The keypad is housed in a rugged cast aluminum enclosure that can be mounted to a pedestal or bolted directly to a wall. Linear's AK-11 is a digital keyless entry system designed for access control applications. Troubleshooting and Solution DIY FIX for Gate, Door, Garage Entry (video).How to Add New Codes and Delete Old Codes (video).8.8 Changing the 6-Digit Master Programming Code.8.3 Re-entering a Command After a Mistake. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |